Verliezer Posted January 19, 2021 Share Posted January 19, 2021 Does anybody know what the range is you need to stay, in order to keep your territory scanner operating? Link to comment Share on other sites More sharing options...
Aaron Cain Posted January 19, 2021 Share Posted January 19, 2021 should always be active. Link to comment Share on other sites More sharing options...
Daphne Jones Posted January 19, 2021 Share Posted January 19, 2021 3 hours ago, Verliezer said: Does anybody know what the range is you need to stay, in order to keep your territory scanner operating? As long as you don't log off and don't move the construct the scanner is on, it should be OK. Also, if you're running multiple scanners, you need to save the scan from one before the next one finishes or it will overwrite (unless that's been changed since alpha). Link to comment Share on other sites More sharing options...
Verliezer Posted January 19, 2021 Author Share Posted January 19, 2021 So you can travel where ever you want and the scan still continues? I understood that if you left a certain range, it would stop scanning. Link to comment Share on other sites More sharing options...
Daphne Jones Posted January 19, 2021 Share Posted January 19, 2021 Just now, Verliezer said: So you can travel where ever you want and the scan still continues? I understood that if you left a certain range, it would stop scanning. I've been a few km away mining another hex with no problem. I can't vouch for going further, but it seems to run in your client wherever you are - unlike PBs which need you to be relatively close. Link to comment Share on other sites More sharing options...
Verliezer Posted January 19, 2021 Author Share Posted January 19, 2021 2 hours ago, Daphne Jones said: I've been a few km away mining another hex with no problem. I can't vouch for going further, but it seems to run in your client wherever you are - unlike PBs which need you to be relatively close. ok, tx!! Link to comment Share on other sites More sharing options...
TacticalDonut Posted January 20, 2021 Share Posted January 20, 2021 There is an issue with rendering causing moving of your construct thus pausing your scan, So once you leave render, don't go back to it until it is finished (since it won't be tracking movement once it's done) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now